Инструкция для Timberk THU UL 04

ENGLISH

Fig. 3

19 - Increase the humidity level (+)

20 - Set the steam atomization frequency
21 - Set the timer (+)
22 - Set the warm steam mode
23 - Decrease the humidity level (-)
24 - Select operation modes 
25-Set the timer (-)
26 

- Unit's on/off button

27 - Base under the water tank
28 - Ultrasonic membrane
29 - Water level sensor (float)
30 - Water valve axis
31 - Water receiver
32 - Air vent
33  -  Cleaning  brush  (not  included  in 
the mandatory scope of delivery)

Fig. 4

SCOPE OF DELIVERY

1. Humidifier-1 pc.

2.Operation manual-1 pc.
3. Guaranteecard-1 pc.
4. Packing-1 pc.

5.  Filling tank with water

Prior to filling the tank remove the atomizer from the tank. If you fail to do 
so, then upon turning over the tank the atomizer will fall down.The device 
must not be operated without the atomizer.

When  moving  the  humidifier  do  not  grab  the  water  tank  handle.  You 
should hold the humidifier by the base.

Fig. 5

1. Remove the atomizer and then the water tank from the device.

2. Grab the tank handle and pull it upwards.

3.  Unscrew the tank cap 
counterclockwise.

Fig. 6

4.  Fill the tank with 
water.

5. Screw the tank cap clockwise.
Make sure the tank cap is securely tightened. Be 
sure that the rubber gasket is installed to the tank 
cap. Securely tighten the cap clockwise.
Incomplete fulfillment of the abovementioned 
measures causes the air coming into the water tank 
and, as a result, a failure.
6. Install the tank and the atomizer to the device.

Fig. 8

www.timberk.ru • ultrasonic humidifier 13